Difference between revisions of "Washing Spice"
From DMT-Nexus Wiki
m (→Alkaline Solution Washing of Inactive Impurities) |
(→Washing Spice: added procedure for purifying fumarate) |
||
| Line 5: | Line 5: | ||
The purpose of washing is to disperse impurities off of the product or out of a solution containing the product and into an intermediate solvent. | The purpose of washing is to disperse impurities off of the product or out of a solution containing the product and into an intermediate solvent. | ||
| − | ===== Alkaline Solution Washing of | + | ===== Alkaline Solution Washing of Impurities ===== |
Most of the impurities that plague yields tend to be quite soluble in both alkaline aqueous solutions and non-polar solvents. To remove these impurities, an imbalance in equilibrium must be created between these two types of solutions, causing the impurities to disperse into a disposable solution from the solution containing the product. This procedure is commonly used for purifying product from extractions that utilize naphtha or heptane to obtain a whiter product. | Most of the impurities that plague yields tend to be quite soluble in both alkaline aqueous solutions and non-polar solvents. To remove these impurities, an imbalance in equilibrium must be created between these two types of solutions, causing the impurities to disperse into a disposable solution from the solution containing the product. This procedure is commonly used for purifying product from extractions that utilize naphtha or heptane to obtain a whiter product. | ||
| − | {{Procedure|Washing Spice of Inactive Impurities Using Alkaline Solution<ref>[[Acolon 5's Spice Washing Tek]]</ref>| | + | {{Procedure|Washing Spice of Oxidization and Inactive Impurities Using Alkaline Solution<ref>[[Acolon 5's Spice Washing Tek]]</ref>| |
# Saturate a solution of warm water with a weak base such as sodium bicarbonate (baking soda) or sodium carbonate (washing soda) to render an alkaline solution. | # Saturate a solution of warm water with a weak base such as sodium bicarbonate (baking soda) or sodium carbonate (washing soda) to render an alkaline solution. | ||
#* ''sodium bicarbonate can be [[Conversion of Sodium Bicarbonate into Sodium Carbonate|converted to sodium carbonate]].'' | #* ''sodium bicarbonate can be [[Conversion of Sodium Bicarbonate into Sodium Carbonate|converted to sodium carbonate]].'' | ||
| Line 17: | Line 17: | ||
}} | }} | ||
| − | ===== Solvent Washing and Isolation of | + | ===== Solvent Washing and Isolation of Impurities ===== |
| + | |||
| + | Some product may contain undesirable active or inactive impurities with solubility properties differing greatly from the more desirable components. | ||
| + | |||
| + | {{Procedure|Washing Fumarate Spice of Fumaric Acid and Residual Solvent Using Water<ref>[[FASA Alteration of Final Purification]]</ref>| | ||
| + | # Add a small amount of water in slight excess of completely submerging the product. | ||
| + | # Stir mixture to dissolve the active fumarate component. | ||
| + | # Decant solution off, leaving solids behind. | ||
| + | # Repeat process until no more color change is observed in the solution, but perform once more with a minimal amount of water for good measure. | ||
| + | #* ''the solids remaining should be mainly composed of the excess fumaric acid from the starting material.'' | ||
| + | # Evaporate the solution with or without heat and airflow to achieve purified crystalline fumarate product. | ||
| + | #* ''reduction of the solution by heat and airflow is generally always beneficial, but slow evaporation in the later stages may result in a more uniform and attractive crystalline product.'' | ||
| + | }} | ||
| − | |||
<noinclude> | <noinclude> | ||
Revision as of 17:54, 27 January 2010
 |
Note: | This page has been transcluded to The Nexian DMT Handbook under the Washing Spice section or other locations within or without the handbook. Please markup in consideration of this. The top section header is to remain in place as a reference for subsequent section headers and to allow easy editing directly from the handbook. |
Contents
Washing Spice
The purpose of washing is to disperse impurities off of the product or out of a solution containing the product and into an intermediate solvent.
Alkaline Solution Washing of Impurities
Most of the impurities that plague yields tend to be quite soluble in both alkaline aqueous solutions and non-polar solvents. To remove these impurities, an imbalance in equilibrium must be created between these two types of solutions, causing the impurities to disperse into a disposable solution from the solution containing the product. This procedure is commonly used for purifying product from extractions that utilize naphtha or heptane to obtain a whiter product.
| Washing Spice of Oxidization and Inactive Impurities Using Alkaline Solution[1] |  |
|---|---|
|
Solvent Washing and Isolation of Impurities
Some product may contain undesirable active or inactive impurities with solubility properties differing greatly from the more desirable components.
| Washing Fumarate Spice of Fumaric Acid and Residual Solvent Using Water[2] | |
|---|---|
|
