View source for BLAB - The Big Leisurely A/B

{{ShowInfo|[[Image:Note_error.png]]|'''Note:'''|This page is a transcription of BLAB - The Big Leisurely A/B<ref>BLAB - The Big Leisurely A/B[http://www.dmt-nexus.com/forum/default.aspx?g=posts&t=8293]</ref>. The content is to remain accurate as such.}}


{{materials_list
|
* 450g(one pound) [[MHRB]] (powdered)
|
* 473ml(16fl oz) bottle of 99% [[IPA]]. If one cant get IPA, there are alternative ways described below
* 2.5 liters of water
* 500ml of [[D-limonene]] (100ml per pull)
|
* 5g of [[Fumaric acid]] (probably way more than enough). If one can't get fumaric acid, there are alternative ways described below
* 250g [[Sodium hydroxide]]
* 1 liter of 5% [[Vinegar]]. If one doesn't have fumaric acid, needs another 500ml of vinegar.
|
* Gallon Milk Jug(HDPE #2 plastic)
* Two 800ml(as close as you can) glass jars
* One 100ml(also as close as you can get) glass jar
}}
== Preface ==

So this is the next advancement in D-Limonene extraction teks. It was thought of for the Nexus by usweyoume. This tek is designed to use LITTLE space with lots of bark for HIGH yields. Nothing really more to say except this Tek was written while on the final material, pharma style '''ONTO THE TEK'''

== The Process ==

=== Step One ===
Take your gallon jug and pour 1 liter of vinegar into it. Then add your pound of bark. Shake this hard to get it all mixed up. Then put it somewhere and let it sit for 3 days.

=== Step Two ===
'''WEAR GLASSES'''. Add 500ml water to one of the large glass jars. Then slowly and carefully add 250g sodium hydroxide to it. Make sure this all gets absorbed into the water. Then after the lye water solution has cooled down, pour this into your gallon milk jug that has the vinegar and root bark in it. Then add around 1.75 liters of water to the jug to top it off(you want enough room at the top for 100ml of d-limonene). Now mix this together very well.

=== Step Three ===
Add 100ml of d-limonene to the gallon jug and mix it together. Don't shake it, just mix it end over end gently. Be careful to keep the cap on the milk jug. The first 2 pulls can be done in about 1-2 hours. After about an hour of mixing then separating and mixing and separating, pull as much of the d-limonene off the top as you can and put it into the other big glass jar. Do this again with another 100ml of d-limonene, mixing for an hour then pulling. The next three 100ml pulls will need to sit for a while longer to make sure you get all the dmt. Do at least one pull a day for three days. Mixing as often as you think about it. Add each pull to the dmt d-limonene jar.


<table><tr><td>[[File:extraction jug.jpg|200px|thumb|left|Extraction jug with limo layer on top]]</td></tr></table>

=== Step Four ===

If you can find both fumaric acid and IPA, proceed to step 4A. If you can get fumaric acid but not IPA, proceed to step 4B. If you cannot get fumaric acid, proceed to step 4C

==== Step 4A ====

Take your small jar and put 5g fumaric acid in it and then fill the jar with your 99% IPA. Then mix this together until the IPA is completely saturated. This creates Fumaric Acid Saturated IPA(FASI). Most likely you will have excess fumaric acid on the bottom but that is fine. Decant your FASI away from the small jar away from the excess fumaric acid, and into a new container (You could dry that fumaric acid that remained behind and save it to use in some other occasion). Now SLOWLY pour your FASI into your jar of dmt saturated d-limonene. The slower the better. For best results add 10ml FASI every 5 minutes until you dont see any more cloud forming in the d-limonene. This will crash out your dmt from the d-limonene. Allow this to sit for at least 24 hours after you stop putting in FASI so that the DMT Fumarate can fully crash out. After 24 hours add another 1ml of FASI to make sure all dmt has precipitated out. After you collect the DMT fumarate from the jar, put the d-limonene back into the jar and let it sit for a few days. More DMT fumarate will precipitate over time. Proceed to step 5A

<table><tr><td>[[File:FASI.jpg|200px|thumb|left|If you add the FASI slowly, after some hours you can get nice crystals precipitating like this]]</td></tr></table>


==== Step 4B ====

Take your small jar and fill with water. Add a teaspoon of fumaric acid and keep mixing strongly for a minute or two. If all the fumaric acid dissolved, add more and mix again. If there is an amount of undissolved excess fumaric acid on the bottom, you're done. This is your FASW (fumaric acid saturated water). Decant the FASW away from the excess fumaric acid, into a new container (the fumaric acid excess can be dried and used in a future extraction if you want). Mix your limonene pull with some FASW. It can be in a proportion of 5:1, so if you have 100ml limo it can be around 20ml FASW (no need to be exact). Mix well, let the layers separate, and pull your FASW out. No problem if there is still a bit of FASW you cant accurately pull off, just leave it there for the next pulls. Do this 3x and put your FASW pulls together. The limonene can be reused for more pulls on the mimosa if desired, or saved for use in future extraction. Proceed to step 5B

==== Step 4C ====

Mix your limonene pulls with vinegar in a 5:1 proportion (so if it was 100ml limonene, add around 20ml vinegar). No need to be exact. Pull out your vinegar away from the limonene. Do this for a total of 3x, and the limonene can now be reused or saved for future extraction. Proceed to step 5C



=== Step Five ===

If you followed 4A, go to 5A. If you followed 4B, go to 5B. If you followed 4C, go to 5C.

==== Step 5A ====

If the crystals are stuck to the jar, pour off the d-limonene from your now hopefully beautiful crystals, and then turn the jar upside down and put it on a paper towel to absorb any extra D-Limonene that falls out. Allow this to sit out until it dries a bit more. You can use a bit of heat and a fan to speed this process up. Now scrape up your JIMJAM fumarate. If the crystals are not stuck to the jar, pour off the limo through a coffee filter, and let your crystals dry. If there are no crystals but mostly a goo on the bottom, pour off as much limo away from it as possible, then add a bit of warm water to pick the goo up and let it evaporate on a dish on a hot plate or on your oven on low setting with the door open.  In any of the cases, your JIMJAM fumarate will smell mildly of oranges. To get rid of orangy smell and extra d-limonene, you can put the dmt fumarate in around 20ml of water and then evaporate on a hotplate. Alternatively, you can also wash your JIMJAM fumarate with a cold IPA or cold acetone or FASI wash. This isn't necessary as limonene is not toxic but will clean it up a bit. Then, Just let your product dry and you have a great product that can be consumed orally together with a MAOI. Dosages vary a lot from person to person, for some people 30mg of jimjam fumarate together with enough MAOI will be very strong, for others they may need 200mg for decent effects. Start on the low end specially the first tries. For achieving a smokable product, proceed to step six.

<table><tr><td>[[File:FASI2.jpg|200px|thumb|left|If you add FASI too fast or if your limo is being reused already or in later pulls, its possible precipitation is a goo, such as this pic. Proceed as written above to retrieve the fumarates]]</td></tr></table>


==== Step 5B ====

Just put your FASW pulls on a glass dish on a hotplate to evaporate. If you dont have a hotplate you can put it on the oven with the door open and a fan turned towards it to speed up the process. 100 degrees celcius (212 farenheit) is a safe temperature to evap/dry it. When its done evapping, scrape up your product, and you have your DMT fumarate with possibly some unreacted fumaric acid. Since fumaric acid is not toxic and is food-safe, its no problem to have it, but it might make the dosage a bit off, needing more of the product for same effects. To remove unreacted fumaric acid, one can do a cold IPA wash which should dissolve none of the DMT fumarate but some of the fumaric acid. Alternatively one can do a simple water clean up, as described in: [[FASA_Alteration_of Final Purification]].  Your dmt fumarate is ready to be consumed orally together with a MAOI. If you want a smokable product, proceed to step six.

==== Step 5C ====

Put your vinegar pulls on a glass dish on a hotplate to evaporate.  If you dont have a hotplate you can put it on the oven with the door open and a fan turned towards it to speed up the process. 100 degrees celcius (212 farenheit) is a safe temperature to evap/dry it. This will leave you with sticky dmt acetate. This can be made into a tincture for oral consumption, or can be converted into a smokable product, as presented in step six.

<table><tr><td>[[File:dmt acetate.jpg|200px|thumb|left|DMT acetate is a goo, and the color can range from light tan to dark red/brown]]</td></tr></table>

=== Step Six ===
If you did steps 4-5A or B, proceed to the Step 6-fumarates. If you did step 4-5C, proceed to Step 6-Acetates

=== Step 6-Fumarates ===
To achieve a smokable product, you must convert your fumarate to freebase.  To do this, make a small amount of saturated sodium carbonate solution by adding plenty of sodium carbonate to water until no more will dissolve (100ml water is more than enough, you'll probably need just a fraction of it). Decant your water away from any undissolved sodium carbonate. Put your dmt fumarate in a glass container. Heat some water to near-boil, and add a small quantity of the hot water to the glass with the dmt fumarate, until it dissolves completely. Then add the sodium carbonate saturated solution to the container with your dissolved dmt fumarate, and you'll see an immediate clouding (which is dmt freebase precipitating). Keep adding the sodium carbonate solution until no more clouding or color changes occur. Put your container on the fridge for 3-5 days for your dmt crystals to precipitate completely. After its done, you can pour off the water through a coffee filter (just in case so that any floating crystals will be retrieved). Scrape up the dmt stuck to the container, and put it on a filter or a plate to finish drying.  Now you have perfect DMT freebase achieved with non-toxic solvents :)

<table><tr><td>[[File:dissolvedfumarate.jpg|200px|thumb|left|On the left side is the dissolved fumarate. The right side is a sodium carbonate saturated solution. Only a small amount of this sodium carb solution is actually necessary]]</td><td>[[File:dmtwaterprecipitation.jpg|200px|thumb|left|As soon as the sodium carbonate solution is added to the dissolved dmt fumarate, there is a precipitation. Stick it in the fridge for at least 3 days]]</td></tr></table>


<table><tr><td>[[File:freebasewaterprecipitation.jpg|200px|thumb|left|After 3 days, the water is poured off (through a filter just in case), and these are the water precipitated DMT crystals]]</td><td>[[File:nontoxicfreebasedry.jpg|200px|thumb|left|Which when scrapped together look like beautiful white flakes]]</td></tr></table>

=== Step 6-Acetates ===
To achieve a smokable product, you must convert your acetates to freebase.   (under construction)

== Reference ==
<references/>

[[Category:Extraction Tek]]
[[Category:Acid/Base]]
[[Category:DMT]]