Difference between revisions of "CIELO"
(→Extract 👨🏾🔬) |
(→Reclaim Solvent 💚) |
||
| Line 84: | Line 84: | ||
| − | Wash spent extract with sodium carbonate saturated water shaking vigorously (emulsions do not form). Filter any excess sodium carbonate and remove water layer. Freeze and filter out ice crystals. Optionally, remove color soaking over activated carbon for several days an filter. | + | Wash spent extract with sodium carbonate saturated water (about 1/5 of the solvent volume is enough) shaking vigorously (emulsions do not form). Filter any excess sodium carbonate and remove water layer. Freeze and filter out ice crystals. Optionally, remove color soaking over activated carbon for several days an filter. |
= Appendix: Development Notes 🔬= | = Appendix: Development Notes 🔬= | ||
Revision as of 18:17, 28 June 2021
Contents
Introduction 🙏
CIELO stands for Crystals In Ethyl-acetate Leisurely Over-the-counter.
In this technique (TEK), cactus lime paste (Fig. 2) is extracted with ethyl acetate (Fig. 3). Mescaline citrate is precipitated with citric acid (Fig. 4) and collected (Fig. 5).
Thanks to everyone who contributed to this process: someblackguy, Benzyme, shroombee, Metta-Morpheus, Downwardsfromzero, Kash, grollum, Mindlusion, Doubledog, Dreamer042, merkin, Loveall, and others.
Safety ⛑️
Review ethyl acetate's[1] and citric acid's[2] safety information. Verify solvent MSDS, plastic compatibility, and clean evaporation.
Following this advice does not guarantee safety. It is up to each adult individual to make their own decision.
Materials 🛒
- French press (or similar ensemble)
- 300g water
- 25g lime
- 100g dry cactus powder
- 1qt ethyl acetate (also sold as "MEK substitute")
- Coffee filters, support basket, and funnel
- Quart jar
- 5g of citric acid (15g is another option)
- Washing soda (for solvent reclaim)
Process 📜
Paste 🌵
Mix water and lime first to make milk of lime in french press (or quart jar if french press is not available). Without giving lime time to settle, incorporate cactus while mixing and continue to mix well for 10 at least minutes to a fluffy smooth paste (Fig. 2). When the mixing is performed properly a change in the paste texture usually occurs. In case of doubt, mix more. This is the same wet paste originally used in the 69ron's limonene TEK [3].
Microwave option: This option breaks down chlorophyll and can make crystallization easier. Simply microwave original paste in short spurts of a few minutes (watch carefully to avoid over boil), stirring frequently until 2/3 of the water evaporates. Paste will change texture through the process, goal is loose wet fluff. Extract will be tan instead of green in the next step.
Extract 👨🏾🔬
Cover paste with ethyl acetate, mix well for 60s, allow to rest for 120s and decant into quart jar through a coffee filter. Do not squeeze with the french press, its purpose is to only hold back the paste from falling into the filter and squeezing can push unwanted excess water into the extract. Repeat until quart jar is full (~5-6x).
Extraction should be complete in less than 30 minutes, after that amount of time the paste begin to congeal. There is plenty of time to perform the pulls by remaining focused on the task.
Inspect extract for droplets or particles. If present, remove them. Extract needs to be clean (see Fig. 3). To be sure extract is clean, one extra pass through a fresh coffee filter after settling is recommended.
Crystalize ✨
Drop citric acid into extract and let it slowly dissolve by diffusion over time. Clouds form, followed by mescaline citrate crystals. Crystals can have different shapes and sometimes also stick to the wall looking transparent. Allow crystalization to complete undisturbed (~24 hours).
One crystalization option proposed by shroombee is to use 15g of citric acid and continuous magnetic stirring (or continuous shaking). This produces a fast crystalization and minimizes crystals that are stuck to the wall. Crystals may be smaller with this approach, but the vast majority of them will still be caught by a filter in the next step.
_copy_800x600.jpg)
Collect 💖
Catch loose crystals in a coffee filter. Rinse crystals on wall and in filter with fresh ethyl acetate (~2-3x until off color is removed). Collect crystals stuck on the jar walls by dissolving them in warm water and evaporating. Combine with the collected crystals from the filter to obtain the final product (Fig. 5).
Yield depends on the cactus and is usually between 0.2% to 2% with ~1% being common[4]. By weight, mescaline citrate is equivalent to mescaline sulfate dihydrate and 90% as strong as MescalineHCl. Oral Dosage recommendations can be found elsewhere[5].
Mass spectrometry (MS) results from solaris analytical[6] indicate the product is very clean mescaline (Fig. 6).
Reclaim Solvent 💚
Reusing solvents is encouraged[7] at the DMT nexus.
Wash spent extract with sodium carbonate saturated water (about 1/5 of the solvent volume is enough) shaking vigorously (emulsions do not form). Filter any excess sodium carbonate and remove water layer. Freeze and filter out ice crystals. Optionally, remove color soaking over activated carbon for several days an filter.
Appendix: Development Notes 🔬
Paste 🌵
No improvements were seen with longer basing time, drying, or increasing the ionic strength.
Paste made with sodium carbonate saturated water congeals over time and requires long solvent soaks which are darker and don't crystallize to large loose crystals (small sticky crystals were obtained).
In the optional microwave treatment, Microwave Assisted Saponification (MAS[8]) breaks down esters (generally soluble in ethyl acetate which is itself an ester) into carboxylate ions and organic alcohols. An important example is,
This breakdown reduces the total amount of plant matter in the extract. For example, large esters are extracted as smaller organic alcohols. The resulting extract has improved crystallization, but this step is not required to obtain a product.
Extract 👨🏾🔬
Tests with longer/warmer pulls resulted in darker extract, smaller crystals, solvent paste absorption, congealing of paste, and no yield benefit.
Chemically drying the extract with a frying agent such as anhydrous CaCl2 or MgSO4 had no benefits.
Crystalize ✨
During crystallization, every 233mg of citric acid (H3Cit) react with free base mescaline (Mes) to form to 1g of mescaline citrate (or slightly more if a hydrate is precipitating):
Excess citric acid shifts the precipitation reaction to the right (Le Chatelier's principle), helping overcome water and plant material. There is a lot room for excess citric acid in solution since its solubility is 50mg/g in ethyl acetate. The TEK recommends ~5mg/g but since cacti and pull techniques can vary, users may find other values work better for their specific situation (in one example with whole cactus powder 20mg/g was used [9]).
Several factors can make crystals smaller: Reusing ethyl acetate, longer/warmer pulls, higher citric acid concentration, mechanical agitation, and other potential variables. Small crystals can look like a fine powder. Potency does not seem affected by the crystallization appearance, and a powdery precipitate is not a problem unless it becomes difficult to decant/filter.
After the initial crystallization, adding more citric acid and/or moving the extract to the refrigerator did not result in any more precipitation. Moving the extract to the freezer produced ice crystals.
Other dry organic acids could work. Fumaric, Malic, Tartaric, Ascorbic, Succinic, etc can be tested in future investigations.
Collect 💖
Washing crystals in a filter appears to wick away plant colors and superior to decanting.
The washed crystals in the filter can also be dissolved in warm water along with any wall crystals. This will give then final product a uniform appearence.
