 |
Note: | This page has been transcluded to The Nexian DMT Handbook under the Machine-Style Bubbler Piece section or other locations within or without the handbook. Please markup in consideration of this. The top section header is to remain in place as a reference for subsequent section headers and to allow easy editing directly from the handbook. |
| the Improvisation of the Bubbler Bowl Variation of "The Machine"
|
 |
| NOTE |
 |
| This variation can apply to the use of a small bubbler pipes, bong-style bubblers, or improvised bubblers, though smaller bubblers are often found most preferable.
|
|
 A Machine-Style Bubbler Bowl being loaded.
- Prepare a plug made of metal mesh by cutting a piece of an excess of the appropriate size to fit in the bowl.
- Stainless steel and copper of a coarse mesh are preferable, as they do not tend to burn at the temperatures needed for vaporization.
- Using pliers to hold the cutting, use a torch to thoroughly burn off any machine oil or coatings found on the mesh.
- Perform this step until no more smoke can be observed emanating from the cutting.
- Allow to cool and roll the cutting tight enough to fit in the bowl.
- The plug needs to be tight enough to suspend it in the opening but not so tight as to block air passage.
| NOTE |
|
| The water in the bubbler acts only as a heat-sink and will not absorb a significant, if any, amount of product, as the freebase product is not very soluble in water; however, the use of ice in cooling should be forgone, as it may cause the premature precipitation of product within the chamber.
|
|
|
Notes on Administration:
- To load, simply place a measured dose directly on top of the plug and carefully melt into the plug by feathering with a flame or other heat source.
- Though a standard lighter will work for vaporizing if used carefully, a torch will ensure a fuller dose.
Alternative Machine-Style Bubbler Pieces:
- The Mini-Machine Bubbler Stem
- The Inspirator
Reference
