Difference between revisions of "Amor fati's Guide to Juremala"

Revision as of 16:58, 31 March 2010

Note:

This page tracks the development of Amor fati's Guide to Juremala.[1] The content is to remain accurate as such.

Note:

This page is a work in progress -- its content throughout is not yet complete.

Linguahuasca regards the administration of harmaloids sublingually to activate sublingual spice as a variation to Pharmahuasca, as well as to potentiate vaporized spice. It is most commonly used to lengthen the effects of spice while simultaneously resulting in a more comprehensible experience of a more personable quality. Linguahuasca is generally considered a more efficient route of administration than oral pharmauasca in that the dosage required is more minimal, irritation to the stomach is not a factor, and the effects do not rely on the state and contents of the digestive system.

Production of Spice Tinctures

1. Add ~74mg/mL full-range freebase to the intended dropper bottle.
2. Dissolve in distilled white vinegar (5% acetic acid), converting to an acetate salt, by shaking vigorously and submerging in a hot-water bath.
3. Evaporate contents in a food-dehydrator at a temperature below 39°C, with the opened bottle stabilized as close to the fan as possible.
4. Refill with vinegar in order to preserve the contents to prevent spoiling and as a tincture of known concentration.

Dosage Character, Amounts and Ratios

It is often found that dosage are easier to measure and administer in the form of a tincture, whereby the number of drops can determine the amounts administered by the known concentration of the tincture.

• 30mg-40mg worth of full alkaloid spice acetate or fumarate, dry or in a concentrated tincture.
• >40mg THH to activate sublingual spice, 15mg-30mg to potentiate vaporized spice.
• 1:1-1:2 of spice to total harmaloids administered to activate sublingual spice.
• Less harmaloids necessary with use of stronger RIMA's like harmaline.

Maximizing Sublingual Mucosa Absorption

For powders and tinctures alike, it is necessary to maximize surface area contact while minimizing dilution by saliva. The most common manner of administration is to leave the powder in a pile or the tincture in a puddle and wait in agony for 5min. while saliva continues to build, but this is unnecessary and inefficient. Spreading the agent as much as possible upon sublingual application will help to reduce burn in the case of tinctures and to increase surface area contact. Following application, it is best to rapidly spread the agent with the bottom of the tongue to further maximize contact between the agent and the mucous membrane. Saliva must not be allowed to accumulate during administration, as so to avoid this, one should swallow any saliva before it has a chance to accumulate, tilt the head back, and breath deeply to help keep the mouth drier.

1. Apply thinly to reduce burn and increase surface area contact.
2. Spread rapidly with the bottom of the tongue to maximize surface area contact and hasten absorption.
3. Prevent dilution by taking measures to keep the mouth as dry as possible.

References

1. ↑ amor_fati's Guide to Linguahuasca WIP Forum Thread[1]