Difference between revisions of "DIY vacuum filtration system"
From DMT-Nexus Wiki
(→Step Three) |
|||
| (3 intermediate revisions by one user not shown) | |||
| Line 3: | Line 3: | ||
==Introduction== | ==Introduction== | ||
| − | All equipment can be obtained from Bunning's | + | Here's a DIY guide on creating your very own vacuum filtration system. All equipment can be obtained from Bunning's |
==Required Equipment== | ==Required Equipment== | ||
| Line 31: | Line 31: | ||
[[File:DIY_vacuumfilter_pump_2b.JPG|400px]] | [[File:DIY_vacuumfilter_pump_2b.JPG|400px]] | ||
| − | [[File:DIY_vacuumfilter_pump_3.jpg| | + | [[File:DIY_vacuumfilter_pump_3.jpg|370px]] |
==Step Four== | ==Step Four== | ||
| Line 43: | Line 43: | ||
[[File:DIY_vacuumfilter_pump_5.jpg|400px]] | [[File:DIY_vacuumfilter_pump_5.jpg|400px]] | ||
| − | [[Category:Tek]] | + | ==Usage== |
| + | To create the one-way pump, hold your finger over the "Shottie" hole when pulling, then take your finger off when flowing pushing the pump back in. | ||
| + | |||
| + | [[Category:Administration Tek]] | ||
Latest revision as of 15:26, 1 May 2014
Contents
Introduction
Here's a DIY guide on creating your very own vacuum filtration system. All equipment can be obtained from Bunning's
Required Equipment
- Suction pump drain cleaner
- 25mm x 90cm Clear vinyl tubing
- 17-32mm Stainless steel hose clamp
- Some Rubber bands
- Funnel
Step One
Unscrew suction piece off the drain pump.
Step Two
Wind a few rubber bands around the tip of the drain pump - this will ensure an airtight fit when the clamp is tightened.
Step Three
Burn or cut a small "shottie" hole near the tip of the clear tube, then fit the clear tubing onto the pump.
Step Four
Screw the steel clamp on tight.
Step Five
Place in bucket and fit the funnel into the end of the hose. The hose should be flat along the bottom of the bucket, which holds the hose stable when the funnel is full.
Usage
To create the one-way pump, hold your finger over the "Shottie" hole when pulling, then take your finger off when flowing pushing the pump back in.
