Difference between revisions of "DIY vacuum filtration system"
From DMT-Nexus Wiki
(Created page with " ==Introduction== All equipment can be obtained from Bunning's ==Required Equipment== * Suction pump drain cleaner * 25mm x 90cm Clear vinyl tubing * 17-32mm Stainless ste...") |
(→Step Three) |
||
| Line 28: | Line 28: | ||
==Step Three== | ==Step Three== | ||
| − | Fit the clear tubing onto the pump. | + | Fit the clear tubing onto the pump. |
[[File:DIY_vacuumfilter_pump_3.jpg|400px]] | [[File:DIY_vacuumfilter_pump_3.jpg|400px]] | ||
Revision as of 14:03, 30 April 2014
Contents
Introduction
All equipment can be obtained from Bunning's
Required Equipment
- Suction pump drain cleaner
- 25mm x 90cm Clear vinyl tubing
- 17-32mm Stainless steel hose clamp
- Some Rubber bands
- Funnel
Step One
Unscrew suction piece off the drain pump.
Step Two
Wind a few rubber bands around the tip of the drain pump - this will ensure an airtight fit when the clamp is tightened.
Step Three
Fit the clear tubing onto the pump.
Step Four
Screw the steel clamp on tight.
Step Five
Place in bucket and fit the funnel into the end of the hose. The hose should be flat along the bottom of the bucket, which holds the hose stable when the funnel is full.
