House's cacti preparation tek

Note:

This page is a transcription of "The Way" Cacti Resin Tek. The content is to remain accurate as such.

Did you know you can evaporate your filtered san pedro tea (ie: oven@150F or food dehydrator) to yield a resin that is easily scraped up with your fingers and rolled into capsules? (It has a Taffy-like consistency)

This resin is far superior to pure extracted mescaline.

There's so much more to it...you gotta see for yourself.

This is golden, glowing, soul food.

You can get far more out of your cacti this way.

Step 1

Just simply simmer or crock pot your pedro chunks (sliced like food) for as long as you want. A dash of lemon is optional, NOT necessary. Simmer gently anywhere from a few hours to a day. You can even freeze/thaw your pedro before hand to break down the cell walls. You can even put your pot of pedro in the freezer overnight if you are too tired to cook any longer. The shorter the simmer, the purer and whiter your xtals will be. The longer, and hotter, the more resiny gunk you will get. The former is preferred.

3 1-2 hour simmers are usually sufficient.

Step 2

Once cooked, you pour off into pyrex dish and reduce in the oven or food dehydrator to acquire this xtal/resin medicine. If you did it properly, YOU DON'T EVEN NEED TO FILTER. Your chunks should be intact, DO NOT MASH THE PEDRO!

Administration

Jorkest and I estimate there is at least 70mg mescaline in each 00 cap of resin.

5 caps is entheogenic bliss. You can feel it's healing effects well throughout the week with every toke, every mocha

Seriously don't waste your time with mescaline crystals, work with the spirit of san pedro it might change your life this method has mine!

Effects

I would describe it's effects like an organic "candy flip" (slang for LSD+MDMA) while remaining comfortable and lucid. Deep emotional healing, and strength are acquired. Even spectacular with caapi. Needless to say, I'll never eat molly again.

Pictures

The following pictures were taken by SWIM.

Step 1

Get the water boiling, toss in the cacti and add citric acid and bring to a simmer.

Keep simmering it. The water will turn into a nice dark brown. Add water as necessary.

Step 2

Filter the cacti from the water and pour it into a pyrex pan.

Step 3

Put it in an oven to evap or in the open air, using a fan is recommended.

Make it into a nice thick resin by moving it around to let it breathe. At this point it's going to be very liquidy, it's recommended to put it in the oven until it completely hardens.

Put in lots of your energy and swirl it around. The idea is to let oxygen into all parts of the mixture.

Soon, it will become quite hard and easy to work with. This is when you want to cap it. Be careful not to handle it too much as your hands will heat up the resin and make it sticky again.

The result!