Difference between revisions of "DIY vacuum filtration system"
From DMT-Nexus Wiki
(→Step Three) |
(→Step Five) |
||
| Line 42: | Line 42: | ||
[[File:DIY_vacuumfilter_pump_5.jpg|400px]] | [[File:DIY_vacuumfilter_pump_5.jpg|400px]] | ||
| + | |||
| + | |||
| + | To create the one-way pump, hold your finger over the "Shottie" hole when pulling, then take your finger off when flowing pushing the pump back in | ||
[[Category:Tek]] | [[Category:Tek]] | ||
Revision as of 13:10, 30 April 2014
Contents
Introduction
All equipment can be obtained from Bunning's
Required Equipment
- Suction pump drain cleaner
- 25mm x 90cm Clear vinyl tubing
- 17-32mm Stainless steel hose clamp
- Some Rubber bands
- Funnel
Step One
Unscrew suction piece off the drain pump.
Step Two
Wind a few rubber bands around the tip of the drain pump - this will ensure an airtight fit when the clamp is tightened.
Step Three
Burn or cut a small "shottie" hole near the tip of the clear tube, then fit the clear tubing onto the pump.
Step Four
Screw the steel clamp on tight.
Step Five
Place in bucket and fit the funnel into the end of the hose. The hose should be flat along the bottom of the bucket, which holds the hose stable when the funnel is full.
To create the one-way pump, hold your finger over the "Shottie" hole when pulling, then take your finger off when flowing pushing the pump back in
