Difference between revisions of "House's cacti preparation tek"

From DMT-Nexus Wiki
Jump to: navigation, search
(Administration)
(mescaline tea trichocereus tea san pedro achuma bridgesii peruvian torch peruvinas)
 
(23 intermediate revisions by 4 users not shown)
Line 1: Line 1:
{{ShowInfo|[[Image:Note_error.png]]|'''Note:'''|This page is a transcription of "The Way" Cacti Resin Tek<ref>Resin. The way to go. [http://www.dmt-nexus.com/forum/default.aspx?g=posts&t=7362]</ref>. The content is to remain accurate as such.}}
+
By simmering chunks of San Pedro and evaporating the decanted liquid, you can yield off white to tan crystalline alkaloids.  
  
  
Did you know you can evaporate your filtered san pedro tea (ie: oven@150F or food dehydrator) to yield a resin that is easily scraped up with your fingers and rolled into capsules? (It has a Taffy-like consistency)
+
== Step 1 ==
  
This resin is far superior to pure extracted mescaline.
+
Carefully cut the green skin off of the San Pedro any way you feel comfortable and put this in a plastic bag. The middle section can be composted. Freeze and thaw the bag 3x. Once the cells have been lysed, place the cactus chunks in a large pot of boiling water and simmer / boil for 5 hours. Do not agitate or mash the chunks in any way, this is the key to purity. A good sized chunk is about the size of a thumb, or half of that. Add warm water to your pot if it starts to get low. Remember, using a large pot with more water allows more alkaloids to be extracted faster and easier.  
  
There's so much more to it...you gotta see for yourself.
+
I have heard you can pressure cook San Pedro for only 45 minutes at 15 pounds per square inch but this has not been tested.
  
This is golden, glowing, soul food.
+
Also. The more water you use the better when cooking. If you are using more than a foot you may even want to do a separate cook with fresh water so the solubility rates are higher and can grab the rest of the alkaloids.
  
You can get far more out of your cacti this way.
+
== Step 2 ==
  
 +
Pour off the liquid into a glass and do a quick decant to remove any large organic particles from the solution. Basically transferring liquid from a cup to a cup should be enough to get anything out of there. After that, pour into a baking dish and evaporate.
  
== Step 1 ==
+
== Step 3 ==
Just simply simmer or crock pot your pedro chunks (sliced like food) for as long as you want. A dash of lemon is optional, NOT necessary.
+
Simmer gently anywhere from a few hours to a day. You can even freeze/thaw your pedro before hand to break down the cell walls.
+
You can even put your pot of pedro in the freezer overnight if you are too tired to cook any longer.
+
The shorter the simmer, the purer and whiter your xtals will be. The longer, and hotter, the more resiny gunk you will get.
+
The former is preferred.
+
  
3    1-2 hour simmers are usually sufficient.
+
Now for evaporation: If you are very careful, you can simmer the liquid down in a pot on the stove. A little bird told me she preferred a ceramic pot on medium to low heat and when it gets low to swirl it back and forth until almost all the water has been evaporated. Be very careful as it can burn very easily. Never leave the stove during this phase.  
  
== Step 2 ==
+
Take it off the stove right at the nick of time after evaporation and leave the pot to sit for two days in open air. After a couple days any remaining liquid that you couldn't evaporate on the stove will have evaporated by this time, and a beautiful crystalline powder will have migrated its way in the form of fractals to the top of any resiny substance that was in the brew. You can scrape the powder from the top of the resin.
Once cooked, you pour off into pyrex dish and reduce in the oven or food dehydrator to acquire this xtal/resin medicine.
+
 
If you did it properly, YOU DON'T EVEN NEED TO FILTER. Your chunks should be intact, DO NOT MASH THE PEDRO!
+
If you did this correctly, you can easily just take a razor blade to your pot and begin collecting a very fine and potent powder. You can leave the resin behind in the pot. I'm not sure if it's the ceramic pot, or leaving it out in the air for a couple days, but something about this process separates the alkaloids from any remaining and minimal gunk from the decanted evaporation.
 +
 
 +
If you do not feel confident with this method of evaporation, evaporate in a pyrex dish in the oven on low (~150F) with a fan blowing into the open oven door or just use a food dehydrator.
 +
 
 +
== Resin VS. Crystalline powder ==
 +
 
 +
In the past, this used to be called the Resin Tek. I have changed that because if you follow this process to the T, you will not be ingesting resin, you will be ingesting almost pure alkaloids. Here are some tips to ensure this occurs:
 +
 
 +
- Use fresh cactus and chop it up yourself. Dried powder and dried chunks always yield a gunky product.
 +
 
 +
- Make sure to freeze and thaw your chunks 3x.
 +
 
 +
- Decanting is the key to purity and minimalizing potential resin.
 +
 
 +
- Do not cook longer than 5 hours. You can keep your chunks and cook them again if you want to.
 +
 
 +
- Absolutely no agitation and mashing what-so-ever.
 +
 
 +
- Leave it to sit at room temperature for a couple days. I watched as the fractal powder grew in mass over this time as it
 +
separated itself from other components at the bottom.
  
 
== Administration ==
 
== Administration ==
Scrape xtals and place in capsules or roll into a nice ball and swallow. Simple as that !
+
 
The more, the merrier !
+
Depending on how well you did on this mission, one gram of this extract should be pretty strong. Start there and work your way up until you find your sweet spot.
  
 
== Effects ==
 
== Effects ==
I would describe it's effects like an organic "candy flip" (slang for LSD+MDMA) while remaining comfortable and lucid. Deep emotional healing, and strength are acquired.
 
Even spectacular with caapi.
 
Needless to say, I'll never eat molly again.
 
  
== Reference ==
+
I would describe it's effects like as an organic "candy flip" (slang for LSD+MDMA) while remaining comfortable and lucid. Deep emotional healing, and strength are acquired. Nootropic effects are definitely noticeable.
<references/>
+
  
== Pictures ==
+
== Experiments ==
The following pictures were taken by SWIM.
+
  
=== Step 1 ===
+
A splash of B. Caapi brew was added to a pot of boiling chunks and when evaporated the product was deemed San Paapi. (Term coined by UniverseCannon) Personally I think it would be best to do this tek separately and do a tannin removal on the caapi itself by adding egg white to a cold decanted caapi brew, heating up, stirring, and filtering off the tannin filled egg white once the brew has heated up and cooked the egg. Once filtered, this could be evaporate to yield caapi alkaloids.  
<table>
+
<tr>
+
<td>[[Image:CactiResin001.jpg|thumb|left|500px|Get the water boiling, toss in the cacti and add citric acid and bring to a simmer.]]</td>
+
</tr>
+
<tr>
+
<td>[[Image:CactiResin002.jpg|thumb|left|500px|Keep simmering it. The water will turn into a nice dark brown. Add water as necessary.]]</td>
+
</tr>
+
</table>
+
  
=== Step 2 ===
+
== Reference ==
<table>
+
<tr>
+
<td>[[Image:CactiResin003.jpg|thumb|left|500px|Filter the cacti from the water and pour it into a pyrex pan.]]</td>
+
</tr>
+
</table>
+
  
=== Step 3 ===
+
<references/>
<table>
+
<tr>
+
<td>[[Image:CactiResin004.jpg|thumb|left|500px|Put it in an oven to evap or in the open air, using a fan is recommended.]]
+
</td>
+
</tr>
+
<tr>
+
<td>
+
[[Image:CactiResin005.jpg|thumb|left|500px|Make it into a nice thick resin by moving it around to let it breathe. At this point it's going to be very liquidy, it's recommended to put it in the oven until it completely hardens.]]
+
</td>
+
</tr>
+
<tr>
+
<td>
+
[[Image:CactiResin006.jpg|thumb|left|500px|Put in lots of your energy and swirl it around. The idea is to let oxygen into all parts of the mixture.]]
+
</td>
+
</tr>
+
<tr>
+
<td>
+
[[Image:CactiResin007.jpg|thumb|left|500px|Soon, it will become quite hard and easy to work with. This is when you want to cap it. Be careful not to handle it too much as your hands will heat up the resin and make it sticky again.]]
+
</td>
+
</tr>
+
<tr>
+
<td>
+
[[Image:CactiResin008.jpg|thumb|left|500px|The result!]]
+
</td>
+
</tr>
+
</table>
+
  
 
[[Category:Extraction Tek]]
 
[[Category:Extraction Tek]]
 
[[Category:Mescaline]]
 
[[Category:Mescaline]]

Latest revision as of 17:55, 4 November 2011

By simmering chunks of San Pedro and evaporating the decanted liquid, you can yield off white to tan crystalline alkaloids.


Step 1

Carefully cut the green skin off of the San Pedro any way you feel comfortable and put this in a plastic bag. The middle section can be composted. Freeze and thaw the bag 3x. Once the cells have been lysed, place the cactus chunks in a large pot of boiling water and simmer / boil for 5 hours. Do not agitate or mash the chunks in any way, this is the key to purity. A good sized chunk is about the size of a thumb, or half of that. Add warm water to your pot if it starts to get low. Remember, using a large pot with more water allows more alkaloids to be extracted faster and easier.

I have heard you can pressure cook San Pedro for only 45 minutes at 15 pounds per square inch but this has not been tested.

Also. The more water you use the better when cooking. If you are using more than a foot you may even want to do a separate cook with fresh water so the solubility rates are higher and can grab the rest of the alkaloids.

Step 2

Pour off the liquid into a glass and do a quick decant to remove any large organic particles from the solution. Basically transferring liquid from a cup to a cup should be enough to get anything out of there. After that, pour into a baking dish and evaporate.

Step 3

Now for evaporation: If you are very careful, you can simmer the liquid down in a pot on the stove. A little bird told me she preferred a ceramic pot on medium to low heat and when it gets low to swirl it back and forth until almost all the water has been evaporated. Be very careful as it can burn very easily. Never leave the stove during this phase.

Take it off the stove right at the nick of time after evaporation and leave the pot to sit for two days in open air. After a couple days any remaining liquid that you couldn't evaporate on the stove will have evaporated by this time, and a beautiful crystalline powder will have migrated its way in the form of fractals to the top of any resiny substance that was in the brew. You can scrape the powder from the top of the resin.

If you did this correctly, you can easily just take a razor blade to your pot and begin collecting a very fine and potent powder. You can leave the resin behind in the pot. I'm not sure if it's the ceramic pot, or leaving it out in the air for a couple days, but something about this process separates the alkaloids from any remaining and minimal gunk from the decanted evaporation.

If you do not feel confident with this method of evaporation, evaporate in a pyrex dish in the oven on low (~150F) with a fan blowing into the open oven door or just use a food dehydrator.

Resin VS. Crystalline powder

In the past, this used to be called the Resin Tek. I have changed that because if you follow this process to the T, you will not be ingesting resin, you will be ingesting almost pure alkaloids. Here are some tips to ensure this occurs:

- Use fresh cactus and chop it up yourself. Dried powder and dried chunks always yield a gunky product.

- Make sure to freeze and thaw your chunks 3x.

- Decanting is the key to purity and minimalizing potential resin.

- Do not cook longer than 5 hours. You can keep your chunks and cook them again if you want to.

- Absolutely no agitation and mashing what-so-ever.

- Leave it to sit at room temperature for a couple days. I watched as the fractal powder grew in mass over this time as it separated itself from other components at the bottom.

Administration

Depending on how well you did on this mission, one gram of this extract should be pretty strong. Start there and work your way up until you find your sweet spot.

Effects

I would describe it's effects like as an organic "candy flip" (slang for LSD+MDMA) while remaining comfortable and lucid. Deep emotional healing, and strength are acquired. Nootropic effects are definitely noticeable.

Experiments

A splash of B. Caapi brew was added to a pot of boiling chunks and when evaporated the product was deemed San Paapi. (Term coined by UniverseCannon) Personally I think it would be best to do this tek separately and do a tannin removal on the caapi itself by adding egg white to a cold decanted caapi brew, heating up, stirring, and filtering off the tannin filled egg white once the brew has heated up and cooked the egg. Once filtered, this could be evaporate to yield caapi alkaloids.

Reference