Cybs' Hybrid ATB 'Salt' Tek - Revision history

Held In Amber: /* Required Equipment */ Added necessary equipment to the list

2023-01-15T13:14:48Z

‎Required Equipment: Added necessary equipment to the list

Dreamer042: /* Step Five: Basifying */

2020-05-29T00:56:42Z

‎Step Five: Basifying

Cyb: /* Introduction */

2016-03-14T09:32:22Z

‎Introduction

AteeBull: /* Required Equipment */

2015-05-18T01:23:13Z

‎Required Equipment

TheTraveler at 13:38, 28 March 2015

2015-03-28T13:38:02Z

Cyb: /* Introduction */

2013-06-13T07:02:10Z

‎Introduction

Cyb: /* Step Six: Adding the Non-Polar Solvent */

2013-04-24T16:50:30Z

‎Step Six: Adding the Non-Polar Solvent

Cyb: /* Step Six: Adding the Non-Polar Solvent */

2013-04-24T16:49:42Z

‎Step Six: Adding the Non-Polar Solvent

Cyb: /* Step Seven: Pulling */

2013-04-24T16:49:12Z

‎Step Seven: Pulling

Cyb: /* Step Seven: Pulling */

2013-04-24T16:48:45Z

‎Step Seven: Pulling

@@ Line 54: / Line 54: @@
 * Glass Roasting Dish (x3) (Not Shown)
 * Food Wrap/Cling-film (Not Shown)
 [[File:Cyb-Tekpic1-EQUIPMENT.jpg|400px|Required Equipment]]

@@ Line 96: / Line 96: @@
 ==Step Five: Basifying==
-'''This step uses lye/caustic soda; the author offers the following caveat regarding its usage and its neutralization in the event of spillage''': ''Caution: Lye is dangerous...do not get any on your skin or eyes.
+'''This step uses lye/caustic soda; the author offers the following caveat regarding its usage and its neutralization in the event of spillage''': ''Caution: Lye is dangerous...do not get any on your skin or eyes. Avoid inhaling fumes when mixing lye with water.
 Use gloves if you have them.

← Older revision		Revision as of 09:32, 14 March 2016
Line 8:		Line 8:

	The tek may be suitable for extracting from other organic materials, such as acacia although only some information on yields or success rates so far.<small>[2]</small>		The tek may be suitable for extracting from other organic materials, such as acacia although only some information on yields or success rates so far.<small>[2]</small>
		+
		+	[[Please note that not all barks contain the same percentages of actives]]...End Results May Vary!!

@@ Line 44: / Line 44: @@
 * Lye (Caustic Soda)
 * White (Distilled) Vinegar
-* Naphtha (Lighter Fluid, e.g. Zippo, Swan, Ronsonol, Newport)
+* Naphtha (Lighter Fluid, e.g. Zippo, Swan, Ronsonol, Newport, Shellite)
 * Spare Jam Jar (Storage of used naptha)
 * Funnel

@@ Line 264: / Line 264: @@
 [[Category:Straight To Base]]
 [[Category:DMT]]
 #[[GALLERY:-]]

← Older revision		Revision as of 07:02, 13 June 2013
Line 30:		Line 30:

	'''Original Post''': [https://www.dmt-nexus.me/forum/default.aspx?g=posts&m=381707#post381707 Cybs' Hybrid ATB 'Salt' Tek]		'''Original Post''': [https://www.dmt-nexus.me/forum/default.aspx?g=posts&m=381707#post381707 Cybs' Hybrid ATB 'Salt' Tek]
		+
		+	'''Cybs' New 'MAX ION' tek''': [https://www.dmt-nexus.me/forum/default.aspx?g=posts&m=459391#post459391 Cybs' New 'MAX ION tek]

	'''Download''': [https://www.dmt-nexus.me/forum/resource.ashx?a=13453 PDF]		'''Download''': [https://www.dmt-nexus.me/forum/resource.ashx?a=13453 PDF]

@@ Line 119: / Line 119: @@
 #Place back in a heat bath. (Heated pulls draw more product)
 #Leave for a while until the naphtha separates again. (edit: ''This has been reported to take an hour or so the first time (occasionally)'')
-#REPEAT THIS '''four times''' (shake/separate). This should take around 45 mins.
+#REPEAT THIS '''four times''' (shake/separate) to thoroughly mix them together. This should take around 45 mins.
 [[File:Cyb-Tekpic10-NAPTHAMEASURE.jpg|240px]]

@@ Line 127: / Line 127: @@
 ==Step Seven: Pulling==
-#After the mixing the naphtha and letting to separate FOUR TIMES to thoroughly mix them together, carefully suck out all the naphtha from the top layer with the turkey baster and squirt it into a glass roasting dish. This takes a bit of patience and skill. Be very careful not to disturb the basified mix (black layer) - Do not suck up any of the basified mix. If you can’t get the last bit, you can suck up the naphtha and a bit of the basified mix and place them in a tall thin drinks glass and wait a short time to separate again. It will be easier to see the layering and retrieve the last bit. Use an eyedropper if necessary.
+#After the mixing the naphtha and leaving to separate FOUR TIMES to thoroughly mix them together, carefully suck out all the naphtha from the top layer with the turkey baster and squirt it into a glass roasting dish. This takes a bit of patience and skill. Be very careful not to disturb the basified mix (black layer) - Do not suck up any of the basified mix. If you can’t get the last bit, you can suck up the naphtha and a bit of the basified mix and place them in a tall thin drinks glass and wait a short time to separate again. It will be easier to see the layering and retrieve the last bit. Use an eyedropper if necessary.
 #The first pulls may be heavily saturated and turn milky when it hits the dish: This is a good sign. Later pulls may look clear or yellowy, but this is also fine.
 #Tightly pull food wrap around the dish to form a sealed lid, airtight and watertight.